Greetings to the group,
I was trying to tune some Mitrek rcvr's. using the service manual
procedure and a TEK-5E test set ( big box with 8 meters on it). The
Mitrek manual says to set meters 1 and 2 to "reverse" for some of the
tuning steps. Now my problem, there is NO "reverse" switch on this
test set, even though the manual says it is one that can be used for
Mitreks. I was used the "C" setting an the selector switch, should I
have used the "A" setting instead ? The manual implies that you flip
a "forward /reverse" switch on the test set.
My question is simple. What is the simplest to provide the reverse
meter readings for meters 1 & 2 in this peice of gear. drill the box
and install a series of DpDT swicths for each of the required meters or
are there any other solutions out there.
TIA for any helpful info.
Doug N3DAB
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/Repeater-Builder/
<*> To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
