Thanks for the link. I do not know what it is but I need a ballpark figure to design around. Its already installed but I have no idea what it is, I have not seen it yet. Its for a receiver link between two parts of a multicoupler between two buildings. The run is around 500 feet. I am figuring the resistives plus mismatch will put it about 10 dB deep.
Thanks, td wb6mie You are probably asking for P3 CATV 500 cable. It is about 1.5 dB at 450 MHz. Go here http://www.trilogycoax.com/pdf/catv/spec_sheets/mc2/MC2_500.pdf to check out Trilogy 1/2" cable, which is air dielectric and has less loss than foam. This cable will work just fine for a RX application. Shorty, K6JSI San Diego Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
