Forgot to ask in the first email... What about a part number for the connect and contacts.
Thanks Eric for the info Jamey Wright -----Original Message----- From: Repeater-Builder@yahoogroups.com [mailto:[EMAIL PROTECTED] Behalf Of Eric Lemmon Sent: Saturday, April 01, 2006 11:24 AM To: Repeater-Builder@yahoogroups.com Subject: RE: [Repeater-Builder] Kenwood Pinout Jamey, The pin assignment of the KCT-19 Option Connector is as follows. When holding the connector with the two side ribs facing to the left, Pin 1 is at the upper left, Pin 3 is at the upper right, Pin 13 is at the lower left, and Pin 15 is at the lower right: 1 RXD (SmarTrunk) or DTC (MDT) 2 Mike ground 3 Ignition sense 4 RX Discriminator output 5 External Mike input 6 Ground 7 Switched B+ 8 External PTT 9 Data modulation input 10 Horn alert output 11 Squelch detect (MDT) 12 Speaker audio 13 Speaker mute input 14 Mike mute input 15 Emergency input (Emergency mode) or TX sense output All of this info is available in the Service Manual B51-8498-10. 73, Eric Lemmon WB6FLY -----Original Message----- From: Repeater-Builder@yahoogroups.com [mailto:[EMAIL PROTECTED] On Behalf Of Jamey Wright Sent: Saturday, April 01, 2006 9:03 AM To: repeater-builder@yahoogroups.com Subject: [Repeater-Builder] Kenwood Pinout Anyone have a pinout diagram for the accessory connector on a Kenwood TK-860? Jamey Wright KD4SIY 444.325 Eva, AL Yahoo! Groups Links Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/