First thing you need to mention, is did you do this test into an antenna or into a dummy load? If in to an antenna, as the SWR goes up, so will the power. If into a dummy load, then it shows it is narrowed for the 450-470 Mhz band, and it would be best to consult them about it. But from what others have said, there amps are very broad banded, at least all that I have read.
n3dab <[EMAIL PROTECTED]> wrote:
Greetings to the group,
Does any one have any specific info on retuning a Henry C200D10R UHF
450-470 rack mount PA into the 440 band ? The PA requires 5-10w to
produce 100-200w out. I can see nothing inside that is adjustable,
all the components are fixed value and securely soldered in place.
The only thing that might be adjusted is the spacing of the coils on
4 wire wound chokes, 2 near the input and 2 near the output.
The PA belong to a friend who purchased it used from a 3rd party, had
it shipped to Henry to put on 443.750, and return for use. A simple
bench test into a 50 ohm dummy load shows that (using a IC2400 mobile
on low power) 8-9w in at 443.750 yields about 45w out but as I
increase the freq. to 462.750 the IC2400 pwr drops to 5-6 w (which I
would expect from from the mobile being out of band) but the PA
output pwr. jumps to over 100w.
My suspicion is that Henry did nothing but make sure it was working
in the deigned band range(450-470) and slap a new label on it and
send it back.
Will compressing the choke coils closer together make any difference
in the freq. range, or do some of the fixed components need
replacing. I know the choke compression worked in retuning a ARR 450-
470 preamp to move it to 440 (per ARR directions). If so, how close
should the coils be spaced ??
TIA for any help
Yahoo! Groups Links
<*> To visit your group on the web, go to:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
Talk is cheap. Use Yahoo! Messenger to make PC-to-Phone calls. Great rates starting at 1¢/min.
YAHOO! GROUPS LINKS
- Visit your group "Repeater-Builder" on the web.
- To unsubscribe from this group, send an email to:
- Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.