Don't have a book in front of me, but I am sure that unit is entirely 12
V DC inside. The change in power level is a programming issue (factory
default output for low power is 10 watts, and you can change it from
dealer mode in the CE27 software) NOTE - I never did check to see if the
low power setting in the software really does change it for the battery
mode as well.
Now for my VXR7000 question ... Is there a way to turn on or off
"anti-kerchunk". I have two units in service, both narrow band with DPL
access. One of these units comes up right away (ie, no delay in tx from
a received signal), and the other unit has more than 1.5 seconds that it
seems to delay before it will turn on the transmit after receiving a
valid signal.
Thanks!!
James
w7cwk wrote:
> I am in need of a service manual or at the least a schematic for a VXR-
> 7000V repeater. Yaesu/Vertex has not been responding to requests. We
> purchased this repeater new and would like to put it in service. The
> site where the repeater will be installed is a solar powered site. The
> 7000 normally runs on 115 VAC. There is a hookup for an emergency
> battery. When the AC mains fail the repeater switches to the battery.
> However, the output drops to 10 watts to conserve battery power. I am
> hoping that this is done by reduced drive, and not a change from say a
> 28 VDC power supply to the external 12 Volts. If anyone knows and can
> help out I would appreciate it.
> Thanks, John W7CWK
>
>
>
>
>
>
>
>
> Yahoo! Groups Links
>
>
>
>
>
>
>
>
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/Repeater-Builder/
<*> To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
