Re: [Repeater-Builder] FLAT AUDIO -- GM300 / MAXTRAC

[James]

All Maxtrac, Radius, GM300, 1225 and CDM series radios have flat audio at pin 5.  I also believe that on most (except CDM, and 1225) there is a jumper inside to allow you to bypass the limiter as well, and bypass the 300 Hz HPF. I do not have books handy, but look at the markings on your board, they might be labeled to some extent. James Maire-Radios wrote: should be a pin out but may need to change a juniper.\   ----- Original Message ----- From: [EMAIL PROTECTED] To: Repeater-Builder@yahoogroups.com Sent: Friday, April 28, 2006 12:53 PM Subject: [Repeater-Builder] FLAT AUDIO -- GM300 / MAXTRAC Hi all!   Maybe I'm going blind (after reading all the small print of the manual)! or I just missed it somewhere...   On the GM300 or Maxtrac:   Is there a software spot or a control switch that send flat audio to the 16 pin accessory connector rather than pre-emp audio?   Thanks Brian, WD9HSY YAHOO! GROUPS LINKS  Visit your group "Repeater-Builder" on the web.    To unsubscribe from this group, send an email to:  [EMAIL PROTECTED]    Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.