I have recently purchased an ICS LinkerIIa controller. Super nice guy on
the phone with prompt shipping.. I have a question for the group..
Where I live we have a lot of problems when we do not use PL/CTCSS on
repeaters for various reasons. So my question is this... I am using a
converted Mitrek plus 50W mobile (of course PA is turned down)
with the HLN4181 tone board.
I understand all of the connections etc (thanks repeater-builder.com!)
to the outside of the radio. I do not intend to run the repeater at
any time in COS mode. It will be in PL mode at all times. If I do this
will I still have to hook up the COS to the repeater controller or
not? I assume that I can just use the CTCSS input on pin 9 of P1
(Port1) on the controller for full control and not hook up pin 8 (COS
input). Is this correct or am I totally looking over something? Again
let me state again the repeater will be in PL decode mode at all
times.. I do not intend to remove the PL at any time..
Thanks ahead of time
Shane KI4M
Ring'em or ping'em. Make PC-to-phone calls as low as 1ยข/min with Yahoo! Messenger with Voice.
YAHOO! GROUPS LINKS
- Visit your group "Repeater-Builder" on the web.
- To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
- Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
