John P Slusser wrote:
> Thanks. I'm going to try that on the internal PLL unit. If that
> doesn't work I'll acquire an external encoder. I'm going to try to
> link using DPL and use PL for user repeater access. This will be a
> first for me. I was hoping that someone had in-depth experience with
> the Kenwood and might share a method.
>
> John in Tucson
I couldn't tell you which pin it is, but encode tone is available on one
of the connectors on the tone panel/controller board in the top of the
repeater (the board were the tone EEPROM is located). You should be able
to find it with the manual and either interrupt it, or pull it to ground
when no tone is desired. Then just bring the control line for that out a
spare pin on the molex on the back where everything else plugs in. There
is one or two that can be used.
--
Jim Barbour
WD8CHL
Rgr. I opened it up yesterday evening and found the enable on the module
responsible for encoding. And that signal originates in the tone panel as
you mention. I'm going to test that theory first. Also, I want to see how
disabling the PL will effect the squelch heard on a user's radio. I still
may elect to use an external encoder if my experiement is not so succssful.
Thanks.
WD7F
John in Tucson
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/Repeater-Builder/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/Repeater-Builder/join
(Yahoo! ID required)
<*> To change settings via email:
mailto:[EMAIL PROTECTED]
mailto:[EMAIL PROTECTED]
<*> To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
