Chuck, Kevin, and Mike, Thanks alot gentlemen. I kinda figured I was going to need the test set. I have already bid for one found on ebay. Thanks for the heads up for a couple others.
I just found that my manual wa assembled wrong. The 2 pages for receiver are for the high band version. Does anyone have a spare or scanned verion of those two pages for the UHF RF and IF board alignment? TLE 8032B with the TLE 8023B band passs filter. Thanks again for everyone's help. N3GH George (W3BD Repeater) --- In [email protected], "n3gh_1" <[EMAIL PROTECTED]> wrote: > > Gentlemen, > Appreciate some direction. > I first connected a controller and tested this unit on it's original > frequency pair (460.625 Mhz +) successfully. Then I send the ICOM's > out for the new amateur frequency pair (443.050 +) Mhz. Upon getting > them back from Bomar in NJ I plugged them in and thought to run a > quick test. > Knowing I would have to realign the receiver and transmitter I still > thought it would work somewhat. I was Wrong!! > No transmitter output, no recieve. > First question is shouldn't the unit worked well enough to receive > some and transmit? > Second question is the manual I have describes the alignment procedure > using the Motorola test set only. Does anyone have test point > descriptions for use with general test equipment? (Scope, DMM, Counter) > Any help would be greatly appreciated. > Thanks > > N3GH > George > (W3BD repeater) >
