I seem to remember Kevin (kuggie) posted a repeater rf levels 
text a year, two or three back.  It was very good and I meant 
to print it out for some friends... but I lost track of when it 
was posted and searching yahoo is sometimes not so easy. 
skipp 

> "Andy" <[EMAIL PROTECTED]> wrote:
>
> Hi all,
> 
> I've been searching old posts and the RB page but haven't found quite
> what I'm looking for, so I'm resorting to spamming the list :-)
> 
> My question has to do with how much TX/RX isolation is required for
> different frequency spacings.  I'm assuming that as the TX/RX
> frequency spacing increases, the amount of isolation that the cavities
> needs to provide decreases.  My question is how do I calculate this?
> 
> For example, if a repeater puts out 50W, for that 50W signal to be
> attenuated to .2uV, something like 154 dB (I think...someone check my
> math) of attenuation would be required. Now, since the TX frequency is
> actually separated from the RX frequency by some amount (let's say 600
> kHz), not all of the TX signal energy is going to be seen by the
> receiver.  However, some of it will be seen...my question is how much?
>  Since a lot of the traffic on this list mentions numbers like 80 dB
> of cavity isolation, I'm assuming that about 80 dB is coming from the
> cavities and the other 76 dB (from the 154 dB mentioned above) is
> coming from the fact that the TX and RX frequencies are spaced apart.
>  So now if we expand the TX/RX spacing from 600 kHz to 5 MHz, how much
> less isolation is required from the cavities, since the spacing is
> contributing more?  Obviously the transmitter and receiver factor into
> this overall equation, but are there some rules of thumb that can be
> used with "averagely clean" receivers and transmitters?
> 
> I'm sure this information is readily available...I'm just having
> trouble finding it.
> 
> Thanks in advance!
> 
> Andy KB9JOZ
>


Reply via email to