This was a repeater config to start with. Worked fine with the onboard controller and when I had it on the hill with my RLC-5. In fact had it linked to my 2 meter machine using 1 controller for a while.
I pulled the rx tone board(maybe that was the system board?) when I got it. Left the TX tone hooked up(the one on the right of the exciter strip). What I was saying was when I pull the connector going to the tone encoder(on the tx strip) the tx went off but would not key with that off. Was trying what Fred suggested. So it was a working full blown repeater that one day keyed on and when I went to the hill to check it there was no way to get it to unkey. No timer or anything. I can pull all but the 10v card and it will stay up. I can change the 10v card ( or the other 2) for known good cards and it stays up. I'm betting that someone out of this group will hit it soon! Ben --- In [email protected], "Nate Duehr" <[EMAIL PROTECTED]> wrote: > > On 2/7/07, w4wsm <[EMAIL PROTECTED]> wrote: > > > Yes, CG is on transmitter. I pulled the cable to it and the TX went > > off. It wouldn't key with the tone disconnected...is there a jumper > > you have to use for no tone? > > I'm sorry, clarify... when you pulled the cable off the exciter on the > left side of the drawer, or did you pull something else off? The > station would stay keyed if you disconnected the PA normally... that's
