Thank you very much Eric. I've flipped through the manual I have twice looking for the page you sent; it's not there. I do have the schematic portion of the SGM, and even the document on the SpectraTAC SGM, but it has a different part number, and I must assume some important differences. The two SGM boards appear very similar though; they probably have the same jumper configurations but I didn't want to head down the wrong path on a hunch. Thanks again; the people on this list really show the amateur radio spirit.
At 05:15 PM 2/18/2007, you wrote: >Robin, > >The information on the TRN5324A Squelch Gate Module is in the >MSR2000 Control and Audio manual 6881061E40, behind the Remote >Control tab. Service Manual Revision SMR-5804 replaced the TRN5324A >SGM with the TRN5331B SGM. > >The Control and Audio manual is an important document for any >MSR2000 owner to have. It is still available from Motorola Parts >for about $57, until the stock is depleted. > >I have sent you the image of the PCB layout directly to your e-mail address. > >73, Eric Lemmon WB6FLY > > >-----Original Message----- >From: [email protected] >[mailto:[EMAIL PROTECTED] On Behalf Of Robin Midgett >Sent: Sunday, February 18, 2007 1:43 PM >To: [email protected] >Subject: [Repeater-Builder] MSR2000 Squelch Gate Jumpers > >Hi guys, >I'm trying to help our local club configure a MSR2000 for our >repeater station. This is my first venture into the MSR2000; my prior >but limited experience is with the Micor & MASTRII stations. >The MSR2000 we have used to have remote control accessories >incorporated into it (guard tone controller & F1 PL control). I've >removed those, and configured the jumpers on the back of the control >chassis for RA (repeater station) operation per the manual. > >I'm now trying to locate all the jumpers on the squelch gate card (we >have TRN5324APR) so that I can set them as needed. When setting the >jumpers on the control chassis, I found it helpful to seek the jumper >locations by looking at both the back plane PCB and/or the manual. >The manual I posess doesn't have (at least I've not yet found it) a >picture of the squelch gate board showing the jumper locations. The >locations are marked on the PCB, but it's a jumbled arrangement with >some of the text obscured by other parts or a smeared silk screen job. >Do any of you know where there's a print of the squelch gate board >online I could view? > >Thanks, >Robin Midgett K4IDC >VHF+ Glutton EM66se > > > > > > > >Yahoo! Groups Links > > > Thanks, Robin Midgett K4IDC VHF+ Glutton EM66se
