(2nd post) Eric
I scanned the Jumper Table and schematic of the MSR2000 PL Board. You can find it here: http://www.w0dp.com/msr2000_pl.pdf I believe Skipp answered all your other questions. Good luck. 73, John Maurer WØDP ----- Original Message ----- From: kk2ed To: [email protected] Sent: Friday, February 16, 2007 12:42 PM Subject: [Repeater-Builder] MSR2000 PL board questions Just picked up a used PL board for an MSR2000 and have a few questions: 1. I need to replace the reeds for my desired PL freq. The unit came supplied with two vibrasponder reeds (same PL). I want to use the card for decode as well as tx encode out. Do I also need to continue to use two vibrasponder reeds, or do I need to use one 'sponder and one 'sender reed in the two slots (sounds more logical)? 2. Which socket is the tx and which is the rx socket? 3. Does anyone have a scanned image of the PL board schematic and/or jumper listings? Unfortunately I don't have a audio&control manual around. Anyone have any experience with effect on receiver audio quality with the PL filter inline versus out of line? Reason I ask is that I originally set up the repeater with a TS64 board (which failed), and left JU1 on the audio card in place. The receiver audio has excellent freq response. I was planning on removing the JU1 once I install the OEM PL card and remove the TS64, thus inserting the PL filter in line with the rx audio feeding the controller. I'm hoping the freq response remains the same. My experience with Micor base receivers is that the PL filter changes the audio response, thus the extra cap tht is jumpered in when the filter is not present. Hence the question.... Thanks Eric KE2D www.w2njr.org ------------------------------------------------------------------------------ No virus found in this incoming message. Checked by AVG Free Edition. Version: 7.5.441 / Virus Database: 268.18.1/690 - Release Date: 2/16/2007 2:25 PM
