hi skipp, i rememember there was something about jumpers to adjust the tail,i think you have it. i will go at the radio site this week end and check it
thanks for those specs,, really appreciate gervais,ve2ckn/va2dq ----- Original Message ----- From: skipp025 To: [email protected] Sent: Sunday, February 18, 2007 12:07 AM Subject: [Repeater-Builder] Re: MSR2000 ,where to adjust the duration of the tail?? Hello Gervias, Two places control the majority of your tail time. If you're using a repeater controller with the factory modules both have settings/jumpers. If you have a bare MSR-2000 Repeater the tail time is selected with a jumper on the Squelch Gate Module. The jumper can be placed on a number of available factory time periods in seconds. There are two "loose wire jumpers" on the Squelch Gate Module. Only one of the two is the tail time jumper/selector and where the clip slide onto the pin end of the wire... it should be obvious by the silk screen writing on the board what time pins are available. Pick 0 (zero) time and you'll still have a very small hang time (with the stock unmodified repeater). If you have an external repeater controller installed with the factory modules... be sure to set the contoller tail time to a smaller /min value. cheers, skipp > "gervais" <[EMAIL PROTECTED]> wrote: > hi, i have an MSR2000 Vhf running here with a tail at the end of the > transmit, i dont remember exactly where but i do remember it was > somewhere on a slot card that there was a adjustement for the > duration of the tail, i need to short it so it wont have a tail > on Echolink here i need an indication on which one,could i have > some tips please?? > thanks gervais ve2ckn >
