We tuned them individually, so no we did not.
-----Original Message----- From: [email protected] [mailto:[EMAIL PROTECTED] On Behalf Of Ken Arck Sent: Saturday, March 03, 2007 5:19 PM To: [email protected] Subject: RE: [Repeater-Builder] repeater problems, duplexer etc. At 01:11 PM 3/2/2007, you wrote: Not a mobile, it's a celwave rack mount 99147 6 cavity, we tuned pass first and then notch,. Into a 50 ohm load, <---Did you have a 50 ohm load on ALL THREE PORTS when you tuned? Ken -----Original Message----- From: [email protected] [ <mailto:[email protected]> mailto:[EMAIL PROTECTED] On Behalf Of Ken Arck Sent: Friday, March 02, 2007 12:06 PM To: [email protected] Subject: Re: [Repeater-Builder] repeater problems, duplexer etc. At 03:38 AM 3/2/2007, you wrote: >Picked up a vertex VXR 7000, and a Celwave 6 cavity duplexer. (VHF) <---What type? One of those mobile notch-only type? How about a model number? >Using Celwave pd-220 3a, with 25 feet lmr. <---Some folks recommend against using LMR in a full duplex system (this topic has been beaten to death on this list by the way but there are good articles at the RB website explaining why) >We have spent hours tuning the duplexer, and find that it makes the >system deaf. <----Keep reading... Using an HT to generate and notch the signals, (as well as a power meter and a swr meter) all looks good until hooked up and its deaf. A user a half mile away can barely hold the repeater on an ht at 5 watts. <----An absolutely HORRIBLE way to tune a duplexer. But still I'll ask - what type of duplexer and,if a notch-only mobile type (which those small ones are), did you tune for notch or pass? And I bet you didn't use 50 ohm pads when you tuned? >Using an HT to generate and notch the signals, (as well as a power >meter and a swr meter) all looks good until hooked up and its deaf. A >user a half mile away can barely hold the repeater on an ht at 5 >watts. > >I fully understand that there is attenuation inherent in duplexers, >but this is way too much. freq pair is 4 mhz split, antenna system >and cabling is excellent, rx and tx on the repeater is great, >duplexer is in excellent shape. > >Anyone have any ideas? Are our crude methods of tuning the duplexer >too crude? we tune the high to pass the high and notch the low (and >vice versa on low side) but the duplexer seems to attenuate much >more than expected. <---See above ------------------------------------------------------------------------ ------ President and CTO - Arcom Communications Makers of the world famous RC210 Repeater Controller and accessories. http://www.arcomcon <http://www.arcomcontrollers.com/> trollers.com/ Authorized Dealers for Kenwood and Telewave and we offer complete repeater packages! AH6LE/R - IRLP Node 3000 http://www.irlp. <http://www.irlp.net/> net
