Can anyone give me a hand with some preliminary questions regarding a UHF repeater (still waiting - after a week - for the owner of the MSF5000 group to approve me!)?
Specifically 2 questions 1) The Batlabs programming cable info says pin 1 of the control (programming) jack is on the left as viewed from the front of the radio, whereas the RB webpage says pin 1 is on the right. Which is correct? 2) The MSF boots up without errors and both Rx & Tx VCO LEDs light at the end. However, putting the unit into xmt (using the front panel switch) only produces a 100 ms (or so) flash of the associated PA LEDs and no RF out. No errors are shown on the 7 segment display. I figure I'd read the codeplug (I have an RIB and RSS) to see how it's programmed but for question one! Also, this unit has the accessory tray with the DTMF decoder/encoder option, as well as the wildcard option, if that makes any difference. (yes, I was even lucky enough to receive a full set of manuals for this exact radio). TIA Ken ------------------------------------------------------------------------------ President and CTO - Arcom Communications Makers of the world famous RC210 Repeater Controller and accessories. http://www.arcomcontrollers.com/ Coming soon - the most advanced repeater controller EVER. Authorized Dealers for Kenwood and Telewave and we offer complete repeater packages! AH6LE/R - IRLP Node 3000 http://www.irlp.net
