what I need to make is a longer jumper for a mastr II mobile that I have converted to repeater service. I am doing the remove the keylock and replace thing and the current jumper is not only too short but was badly assembled. The RCA end is a mess. I had a heck of a time finding a good right angle RCA to start with and now I need to make the other end. I really dont care if it has the hood as long as I can get a good clean cable made that will fit into the hole and tighten down.
Thanks for all the help guys! Dan --- In [email protected], "Eric Lemmon" <[EMAIL PROTECTED]> wrote: > > Dan, > > Are you making up jumpers in the literal sense, or do you actually need a > bulkhead-mount UHF female on one end? If the latter, I suggest using a UHF > female bulkhead connector that crimps right to the cable. That way, you can > take full advantage of the shielding afforded by the RG-400/U cable, without > the leakage of a hood. Ideally, the jumpers in a station cabinet should be > point-to-point without any barrels, adapters, or couplings. > > However, if you really must have the hood, they are available from Mouser. > See Item "V" on this page: > > <www.mouser.com/catalog/630/954.pdf> > > 73, Eric Lemmon WB6FLY > > > -----Original Message----- > From: [email protected] > [mailto:[EMAIL PROTECTED] On Behalf Of Dan > Sent: Sunday, June 03, 2007 5:17 PM > To: [email protected] > Subject: [Repeater-Builder] Chassis mount so-239 with hood? > > Anyone know of a source for these darn things? I want to make up some > jumpers. I have the RG-400 coax but I cant seem to find any so- 239's > with the metal hood over the back! Any ideas? > Thanks for your time! > > Dan/NØFPE >
