Clyde, You need to check where you attached the PTT. The GE base has several PTT points, (remote, repeater, local, combined) depending on the jumpers on the 10 volt card (from 1 to 9 and 2 to 3 I think) the rx mute will turn off the receiver when you transmit / PTT. Its all signaled from the 10 volt card. Try connecting to the PTT from the controller to the repeater PTT first or recheck those jumpers.
Or a butcher would disconnect the rx mute wire in the receiver section 73 Don Kirchner W5DK -----Original Message----- From: [email protected] [mailto:[EMAIL PROTECTED] Behalf Of Clyde Sent: Sunday, July 08, 2007 6:07 AM To: [email protected] Subject: [Repeater-Builder] Duplexing Hi, I have a GE master 2 base that I am converting to a repeater. I did the conversion from the repeater builders web, but I still have a problem. My recieve is still cutting off when the repeater transmits. For a minute second it wants to squeel, then it only transmits with no voice. The controller (NHRC 3+) has a recorded voice programmed at the factory and it goes through, but when I trans on my HT the voice does not go through. The recieve does not stay on so it will go through the transmit. I need help and no one else seems to want to write back. I also have some Motorola Mitreks and I want to convert some of them if you have any Ideas. As you can tell this is my first repeater. Sorry if this is a really dumb question. Clyde
