Ray, see if you can track down the other side of the resistor that feeds your
receive LED. The voltage swing there should be a lot more than you see on the
LED itself.
73 - Jim W5ZIT
Ray Rosler <[EMAIL PROTECTED]> wrote:
----- Original Message ----- From: Ray Rosler
To: Repeater-Builder Moderator
Sent: Wednesday, September 05, 2007 7:20 AM
Subject: KDK UHF 7033
Good morning. I am going to try and make this unit into a link radio and I am
in need to know just where to pick off the COS signal. The controller being
used will be a cat-400. I have found that the receive led goes high when
squelch is opened, but the level is to low to be of any use. any suggestions...
Ray VE5RAE
---------------------------------
Ready for the edge of your seat? Check out tonight's top picks on Yahoo! TV.
