Mushy sounds like there's too much de-emphasis. Make sure you don't have any de-emphasis going on in the controller, either at the RX audio amp or the TX amp. I have a MSR2000 with a CAT controller and the interface via the squelch gate card and it sounds great. Have you followed the alignment of the exciter/deviation as per the manual on the 2000 so that you have the proper compression of the audio and the deviation limited to ~5K, etc.? If you don't have a manual that is a problem. de WD7F John in Tucson
----- Original Message ----- From: "atms169" <[EMAIL PROTECTED]> To: <[email protected]> Sent: Sunday, October 28, 2007 7:23 PM Subject: [Repeater-Builder] MSR2000 + Controller Mushy Audio Hey guys, thanks for all the tips on the MSR2000 conversion. I now have a running MSR2000 and NHRC-5 controller. I have one problem.. the audio sounds mushy, almost emphasized. I tapped in to pin 17 from the Squelch Card but, I think I'm not getting a clean signal. Is there a better spot to tap in to? I read somewhere I might need to remove a resistor off the Squelch Card but, I have no manuals for this. Any help appreciated thanks! Yahoo! Groups Links -- No virus found in this incoming message. Checked by AVG Free Edition. Version: 7.5.503 / Virus Database: 269.15.12/1097 - Release Date: 10/28/2007 1:58 PM Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> Your email settings: Individual Email | Traditional <*> To change settings online go to: http://groups.yahoo.com/group/Repeater-Builder/join (Yahoo! ID required) <*> To change settings via email: mailto:[EMAIL PROTECTED] mailto:[EMAIL PROTECTED] <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
