At 10:10 AM 12/29/07, you wrote:
>I have a Motorola repeater that I'm trying to reprogram.. current
>config is with a CDM1250 TX and M120 RX repeater set-up...  I'm trying
>to program a Motorola M120 mobile... and when I try to read it... the
>software tells me "Model Definition File Not Found" Please insert
>disk... I checked the ".mdf" file on the hard drive and it is in the
>same path as the GM300.exe file  Any help?

I can think of two right off the bat...
1) the MDF and the exe are paired... they have to be the same
revision number (i..e the installation process places both on the
hard drive... are you sure they are matching?
2) were they ever copied to a CD and back?  Moto had a
programming error in some of the RSS where the EXE had to
open the MDF in writable mode, even tho all it ever did was
read it..
If the software was copied to a CD and back it can have the
read-only flag set.
Use the DOS command ATTRIB to fix it.

To avoid that problem in the future just zip up the software,
then copy the ZIP file to the CD, then copy it back to the
hard disk and unzip it.  The zip and unzip process preserves
all file flags, not just the read only one.

Mike WA6ILQ


Reply via email to