Ralph, Maybe I'm missing something here, but is your station a Micor, or is it an MSR2000? Your subject line and the attachment do not agree.
Please advise what backplane you have- there is more than one and they have significant differences. It is always helpful to identify the part numbers (usually stamped in black ink) of each module, so that we all know what you have. Some modules only work with specific backplanes. 73, Eric Lemmon WB6FLY -----Original Message----- From: [email protected] [mailto:[EMAIL PROTECTED] On Behalf Of [EMAIL PROTECTED] Sent: Sunday, December 30, 2007 2:53 PM To: [email protected] Subject: Re: [Repeater-Builder] Re: Micor Repeater (i hope) Hi All Building a Micor Repeater from Scratch Facts. Mother Board (unified Chassis ) origin unknown. Had to add a jumper for +12Volt to RX. Rx with audio works fine. Not using pl board ( control system does PL) Have great local speaker vol and squelch. Exciter, Tripler, PA and circulator all are in working order Have the following modules in the following slots counting from the right front. Audio Line Driver Slot 1 Station Control in Slot 2 Squelch gate in Slot 7 I can Key the transmit on the station control module The exciter and tripler key up and make power PA power comes up about 2 watts and drops off Power Control module check out in a known good complete Micor repeater. Control Transistor is good and plugged in correctly. Checked voltages Missing (- A Key ) minus A Key on the control module. Station Control Module (-A key ) does NOT come up. Station Control Module works in a known good micor repeater. I can add +12 volt to PA control terminal on the PA and PA makes lots of Power on the correct frequency but that bypasses the Circulator SWR protect etc The intent of the whole mess is to use the minimum of the Motorala modules since the Sierra Radio Control system has provisions for Squelch, PTT, RX and TX pl etc any Ideas?? Ralph, W7HSG
