--- In [email protected], "John Everson" <[EMAIL PROTECTED]> wrote: > > Hello to the group. > > I have an rlc-4 with three ports running. Port 1 is the repeater, port > 2 is the Doug Hall RBI, and port 3 is a half duplex 420 link radio. > The > problem I have is when the port 3 420 link is connected to the port 1 > repeater, I get the port 3 courtesy tone out of port 1 just after the > transmitter starts transmitting, AND after the port 3 rx drops out. I > was trying to use command 047 to delete the courtesy tones for rx > dropout on ports 2,3,and 4, but the controller will not take the > command when I enter it. HOWEVER, it did seem to take the command > once, > but I was not expecting the telemetry, so I have no idea what it was. > That might be where the problem lies. I think I did something I > shouldn't have and screwed the programming. > > Do most of you just empty the macro to delete the courtesy tone? > > Any help? > > Thanks in advance. John ab6li > Hi John,
Command 047 simply enables/disables an event trigger. You had to enter the event trigger as 'eee' to make command 047 do something. You might want to run command 045 and then the 'eee' you entered in your 047 command, to see if the 'eee' command is Enabled or Disabled right now. Again, that is the only thing command 047 does is Enable or Disable an event trigger. That action would stop the coutesy tone that would normally fire when the port 3 RX goes inactive. That courtesy tone would also be sent to all connected ports, including port 1. You can email me off-list if you like, and we can go further into fixing your problem. Shorty, K6JSI
