You have a need for multiple ctcss and dcs operation on a 900 MHz box? s.
> "n9wys" <[EMAIL PROTECTED]> wrote: > > OK, I just got my 900 machine back up and running again this morning. For > those who don't remember, this is a MaxTrac Receiver / Com Spec TP-3200 > controller / GTX exciter / Motorola STF2520A paging PA arrangement. > > > > Anyhow - the machine had no audio output at all. nada, zilch. only a dead > key. I changed out the GTX and this restored the transmit audio - I can now > hear voice audio and the ID-er being passed by the repeater. However, one > problem remains: it is still not encoding PL tone. (So if you are in the > area and plan on using the machine, be sure to use CSQ receive for now.) > > > > I have checked and double-checked the panel programming and output - it is > encoding the tone. What I wonder is if the audio circuit in the GTX is > scrubbing off the tone coming from the panel? If so, I can reprogram the > GTX for tone encode on TX, but I'd prefer to use the panel's tone. > (Currently, the GTX is programmed for CSQ transmit.) Also, I'm using Pin 2 > (Ext MIC) for the audio input. should I be using Pin 11 (Flat RX audio) > instead? > > > > Is this an issue that was previously referred to on the list - one regarding > a factory add-on module/fix?? > > > > Mark - N9WYS >
