Norm, There are some jumpers on the 10VDC regulator card that need to be set for CSQ or PL (Channel guard) mode. I disremember the settings, but they are in the manual and documented elsewhere on the web.
There should be an lbi document on the repeater-builders website for the PL board to describe the jumpers. Also one for the 10 VDC card. Note, the stock GE PL deck will only encode or decode, but not full duplex both. In the M II station, the PL board next to the receiver mounted on the system board is usually for decode only. There is an open space next to the exciter for an encode only pl deck. You may not have that installed. They are a little harder to get ahold of. Another recent thread discussed the Comspec TS64M2 ? that is designed to drop into a GE in place of the regular PL deck. It does both encode and decode. You'll just have to run the encode audio over to the exciter connector. Otherwise you can mount an SS-32 or equivalent pl encoder in the exciter section for encode capabilities. Ralph W4XE -------------- Original message -------------- From: "NORM KNAPP" <[EMAIL PROTECTED]> > HELP! > I got a MASTR II repeater... Works great, except I want to add a tone board. > I have a programmable (dip switch) factory board that installs on the system > board. I plugged it in and it made no difference. I looked in the manual and > it > says "for moble, clip jumpers X, Y, and Z. For station installation, see > sation > manual." I have what I thought was a station manual, but I got no > instructions > in there (that I can find) telling me what jumpers to cut or install... > Anyone got any ideas? > Thanks es 73 de N5NPO > Norman Knapp
