> "georgiaskywarn" <[EMAIL PROTECTED]> wrote: > Ok. Put the little op-amp together via the Repeater Builder > website. http://www.repeater-builder.com/rbtip/audioamp.html > I did the one with the 15k resistor and .0047uf cap. Couldn't > tell you what pot I used. Grabbed one and threw it on. Going > to look thru my junk later this week and get a 10 or 50k and > try it. Because the audio is still real low and REAL distorted.
I would expect that... why don't you open up the radio mic and see what type of circuit or element is there..? > However...with what Ron said...made me think about what > another friend of mine said. Isn't the ADI looking for > something like 600ohms? (like a hand mic would be) Much > different than an 8 ohm speaker. You started at the wrong end of the horse... try looking at the information and/or diagram that came with the radio... even the spec sheet or the data sheet for a replacment ADI mic if it's available. > This same setup works with a TM-G707 without any matching...why > shouldn't it work with the ADI? > Robert There's a little thing called "audio level" that also means a lot. cheers, s.
