Ive been searching for that for abt a month now...Im running a 820 with the Arcom Rc210 controller but, and I think u know what im going to say, lol....Wont keyup without COR...let me know if u fand anything out and Ill share with you.
Frank --- In [email protected], XE2SI <[EMAIL PROTECTED]> wrote: > > Hello Skipp, I am here in Tijuana, just across the border with San Ysidro, Ca. > Good it works for you. 73..... > Juan > ----- Original Message ----- > From: skipp025 > To: [email protected] > Sent: Tuesday, January 11, 2005 8:31 AM > Subject: [Repeater-Builder] Re: TKR820 (tkr-720) CORlogic(pin13) informationwanted. > > > > > Just what the doctor ordered. Thanks Juan. > > Su respuesta trabajada muy bien. ¿Qué estado > usted vivo adentro? Tengo familia en GTO, MX > Gracias otra vez mucho. > skipp > > > XE2SI <[EMAIL PROTECTED]> wrote: > > Looks that you have an old repeater, the new ones > > have that pin called TOR wich is what you want, > > if this is the case there is a small square island in the > > controller board near the IC11 ( pin 9 ), this > > change state when there is a valid "PL" received, > > maybe you will need a buffer for what you need. > > hope this helps. > > Juan > > ----- Original Message ----- > > From: skipp025 > > To: [email protected] > > Sent: Monday, January 10, 2005 6:27 PM > > Subject: [Repeater-Builder] TKR820 (tkr-720) COR logic (pin > > 13)informationwanted. > > > > Hello there, > > > > Anyone have information to configure the COR output > > logic on the Kenwood TKR820 Repeater to ctcss only? > > I'd like to make pin 13 (COR) of the accessory > > connector change states with a valid received ctcss > > tone. > > > > As received, accessory pin 13 (COR) changes state > > with carrier squelch activity. This tidbit of knowledge > > seems to be a rather elusive animal. Maybe one of you > > has done this already? > > > > Thanks in advance for your reply. > > > > cheers, > > > > skipp > > skipp025 at yahoo.com > > > > > > > > > Yahoo! Groups Links >
