Hi Tony Based on your information and your callsign I would suspect the MSR-2000 receiver and transmitter modules you have there were probably removed from what I call "Line A and above" radio services (which is a northern portion of the US and Canada) Although we do have a number of Government Services using the UHF Band below our available (in California) 420- 450MHz Amateur (ham) band.
Any MSR-2000 module with RF in/on it was made available in band segments. So the UHF 400-512 band was sliced up into at least 3 segments, maybe 4. Depending on the specific manual and who's telling the story... the US Commercial Radio standard range receiver operates at least 450 to about 490 MHz. Probably lower than 490 MHz but I've seen some mid range receivers "go that high". The high range/segment receiver probably performs ok in 470 to 512 MHz range. And of course there is at least one low range segment that is 400 to 430 MHz? I know the 450-490 MHz range receiver easily goes down into the 440-450 MHz Ham band because I using a number of them in repeater and link operation. Kind of the same band segment offerings with the MSR-2000 transmitter modules although they do tend to be much more wide over their available operational range. The limiting issue with the receiver is the pre-selector and the injection chain. The receiver has a realistic operational range and the nominal usable bandwidth inside that range is reported to be about 4 MHz. There are different adjustment combinations within that range allowing wided rx frequency ranges. I would not expect the 490-512 MHz receiver to come down to the 440 Ham band without way too much work. I would not expect the 400-430 MHz receiver to come up to the 440 Ham band without a lot of work. Most of the above mentioned work is related to working on the pre-selector assembly, which is not an easy task. The real world fix... find a set of replacement transmiter and receiver modules on ebay or offer up a possible trade with someone. Then you have to deal with the rf power amplifier, which is another kettle of fish. Hope that helps a bit.. cheers, skipp skipp025 at yahoo.com > "Tony Lelieveld" <[EMAIL PROTECTED]> wrote: > Hi all, > > I have a UHF MSR2000 repeater and various RX TX modules. The > exciter module is a VTE4001A for 403-430 MHz. The RX module > is a VRE4001B for the 450-512 MHz. > > Has anybody had any success tuning these to the 430-450 MHz > Ham band? The curious part is that the existing RX (VRE4001B) > was used on 416.9375. Are they that wide band at the > front-end preselectors? Any and all information will be > appreciated. > Tony VE3DWI.

