Set the tail time to 0. They are seeing each others tails. You could set the repeaters connecting to port 1 and 2 to "PL on COR" then set the half duplex link radios to pl decode.
Rob. KS4EC Sent by Good Messaging (www.good.com) -----Original Message----- From: tgundo2003 [mailto:[EMAIL PROTECTED] Sent: Friday, June 20, 2008 05:16 PM Eastern Standard Time To: [email protected] Subject: [Repeater-Builder] HELP!!!! In an effort to expand radio coverage for an event coming up- we have done the following: System is a 7330 port 1- Local Micor repeater port 2- Link radio half duplex to another repeater port 3- link radio half duplex to another repeater System is normally port 1 & 2 and it works great. Port 3 is the new addition. No matter what I do- kerchunk delay, anything I try I cannot get 2&3 to stop bouncing between them. Both systems on 2&3 are running real minimal, no ID's, no curt beeps, 1 sec hangtime. I would write a macro to turn off rx3 for 4 sec after rx1 or 2 unkeys, but I wold need the Pause feature of a macro which does not exist yet according to the manual. I'm out of ideas- anyone have any? Thanks!! Tom W9SRV & Brian WD9HSY Since 1974, the award-winning Alpert JFCS has helped families of all faiths throughout most of Palm Beach County, FL, via counseling, seniors services, residences for the disabled, mentoring children, support groups and a lot more. SOLUTIONS FOR LIVING www.JFCSonline.com Please take note of our new website and E-Mail Addresses. Please update your contacts ASAP. -------------------------------------------------------------------------------- NOTICE: This e-mail message and all attachments transmitted with it are intended solely for the use of the addressee and may contain legally privileged and confidential information. If the reader of this message is not the intended recipient, or an employee or agent responsible for delivering this message to the intended recipient, you are hereby notified that any dissemination, distribution, copying, or other use of this message or its attachments is strictly prohibited. If you have received this message in error, please notify the sender immediately by replying to this message and please delete it from your computer.
