Thanks to all that reply to this email, I was able to borrow a unit to read and clone it to my unit got it programmed and working find, and also do a board replacement alignment, with the crystal data and board number TX power, modulation plus PL, every thing turns out fine after factory alignment.
73 W4CSO ----- Original Message ----- From: Thomas Oliver To: [email protected] Sent: Wednesday, August 20, 2008 10:33 AM Subject: Re: [Repeater-Builder] Re: Desktrac UHF 40 Watts Repeater Default Archive Maybe it is not a repeater? Is there two transceiver chassis in the desktrac? tom ----- Original Message ----- From: Camilo So To: [email protected] Sent: 8/20/2008 8:03:08 AM Subject: Re: [Repeater-Builder] Re: Desktrac UHF 40 Watts Repeater Default Archive Thank You Mike, now I know what Joe was explaining TWO software means, But I don't have a problem programming the Maxtrac on out of band, that I already did, my problem was in the programming of the Desktrac front panel, to tell the CPU on the front panel that it was a repeater, because what I have is blank, that is why I am asking the help of this group for the front panel default archive that I can dump the info to the front panel, maybe its not a share item??? Thanks 73 W4CSO ----- Original Message ----- From: Mike Morris WA6ILQ To: [email protected] Sent: Wednesday, August 20, 2008 3:39 AM Subject: Re: [Repeater-Builder] Re: Desktrac UHF 40 Watts Repeater Default Archive At 06:50 PM 08/19/08, you wrote: Hi Joe, I am not aware that there is 2 separate software that is use on Desktrac, What is the version of the software that program the front panel? So that I can order it from Motorola, to my knowledge the only software that is needed to program the Desktrac is RVN4080 version R03,04,00. When you try to read the unit a screen pop up to tell you turn the switch to position 3, then 2, and 1. same as programming the unit, all I need is the default archive to clone the unit. Any one on this group Please correct me if I am wrong. 73 W4CSO See < http://www.repeater-builder.com/maxtrac/maxtrac-index.html> for Desktrac RSS info. Mike WA6ILQ No virus found in this incoming message. Checked by AVG - http://www.avg.com Version: 8.0.138 / Virus Database: 270.6.6/1621 - Release Date: 8/19/2008 6:53 PM
