Does anybody have any .pdf files or similar on the W2EDN line of modules? I picked up an unfinished, but working receiver at the Shelby hamfest, and would like to know the xtal freq range for this 2 meter receiver.
A discriminator meter was installed, but not hooked up. Would need to know if the discrimninator output was available on one of the pins on the board, or if I need to find the spot on the underside. I was told that each module had a name like '10.7 IF', but cant find what the board ID's are, the orignal builder used copper angle and soldered all the board edges to it, I think the board ID's must have been on that edge because only 'W2EDN' could be found undisturbed. It is obvious the original idea was to build a single channel 2 meter rig, but the transmitter board was never installed. Holes were drilled on the back of the enclosure to fit a board that measure about 2 X 6 inches. Any idea what module that would have been? Bottom line info I really need though, is what crystal range was used with his 2 meter RF/MIX/HFO board when feeding a 10.7 IF? Thanks, Charlie in NC W4MEC
