--- In [email protected], "skipp025" <[EMAIL PROTECTED]> wrote: > > Well... > > First: > If you have the original cable set and know the frequency of > design... might be prudent to replace them into service to see > if you can obtain the spec'd notch value. > > I did check these on the original freq and original factory cables with same results
> Second: > You might note the IFR 1600's generator output value and > crank it up min 10dB and better yet 20 dB. Then have a second > look... > Did that > Thanks Joel > cheers, > s. > > > Joel Hall <kj4si@> wrote: > > > > Hope some of you guys that have some experince with db 4060 > duplexer,the pass is fine but the notch is the problem I can see the > notch at around 35db on my ifr 1600s per each can but when i combine > them together about 50db is the best i can get I have new cables made > 1/4 wave long , the tuning caps seem a little flakey may have had been > hit with a lightning surge. > > I have not taken them apart yet so any thoughts? > > > > Thanks kj4si > > >
