Yes, I sent a direct email with the pictures to that address right after you posted the question.
Chuck ----- Original Message ----- From: "Adam C. Feuer" <[EMAIL PROTECTED]> To: <[email protected]> Sent: Monday, October 27, 2008 5:04 PM Subject: Re: [Repeater-Builder] MastrII PA Rack Mount > Jeff and Chuck, > > Thanks for the replies. Not being familiar with the aluminum stock > method, I'll give that some more thought. I'll see what Home Depot has > to offer. I think I might have a blank rack panel to cut so I'll give > that a shot too. > > Chuck, I'd be interested to see the your pics but I didn't get them. > Did you send them to [EMAIL PROTECTED] > > Thanks again guys! > > Adam N2ACF > > Chuck Kelsey wrote: >> I did it with aluminum flat stock and some hex threaded spacers. I sent >> pictures direct to him. >> >> Chuck >> WB2EDV >> >> >> ----- Original Message ----- >> From: "Jeff DePolo" <[EMAIL PROTECTED]> >> To: <[email protected]> >> Sent: Monday, October 27, 2008 3:49 PM >> Subject: RE: [Repeater-Builder] MastrII PA Rack Mount >> >> >> >>> I don't have an M2 PA in front of me to look at, but I would guess it's >>> maybe 17" inches across instead of 19"? How about just getting two >>> pieces >>> of 2" flat aluminum stock, each cut to the height of the PA, drill holes >>> for >>> rack mounting, and holes to line up with the existing mounting holes on >>> the >>> PA heatsink and bolt it on? The Depot and other hardware stores sells >>> aluminum stock (flat, angle, tubing, etc.), not sure how wide they have >>> though. >>> >>> >>> >> >> >> ------------------------------------ >> >> >> >> Yahoo! Groups Links >> >> >> >> >> > > > > ------------------------------------ > > > > Yahoo! Groups Links > > >
