Attach 2 cables to 'Duplex Out' and 'Antenna In' Attach the ends of the cables to the duplexer, Duplex out to 'Antenna' and Antenna In either side. Terminate the opposite side of the duplexer with a 50 ohm dummy load.
Select the Spec Analyzer. Set center range to the first desired tuning frequency. If a BpBr type duplexer I will do the pass frequency, if notch only than I set the notch frequency. Set division to 1 MHz (10 MHz Span) if VHF or 2 MHz (20 MHz Span) for UHF. Set input to 'Antenna In' Select the generator menu Select generator output to 'Duplex Out' Select generator type to sweep Select generator output level to 0dB or +10dB Tune duplexer for desired pass and reject. Select ref level and take down to -50dB for deep notches. If notches are extra deep set generator output to +18dB Change center frequencies and swap cables and do the opposite side of the duplexer. On Wed, Nov 12, 2008 at 1:40 PM, Private <[EMAIL PROTECTED]> wrote: > --- In [email protected], Mike Morris WA6ILQ > <[EMAIL PROTECTED]> wrote: >> >> At 05:48 AM 11/12/08, you wrote: >> >Hi all, >> > >> >New to testing anything with this type of equip.... >> > >> >Just got a Agilent 8924c and have read over the setup docs but I > need >> >actual setup instructions for adjusting duplexer cans. >> > >> >Does anyone have a step by step instruction guide they could send > me so >> >I could learn how to use this new equipment. Instuctions need to be >> >specific to Agilent 8920 or 8924c. >> > >> >Frank >> >> A 20 second Google search on "Agilent Manuals" found: >> > <http://www.home.agilent.com/agilent/facet.jspx;jsessionid=1A652D43ABA > 8052FA80B89F46A4C0ED5.jboss1? > t=80039.k.1&co=152502.i.0&cc=US&lc=eng&sm=g> >> >> Then typing "8924c" into the "model" box found this: >> <http://www.home.agilent.com/agilent/techSupport.jspx? > pid=1000002362%3Aepsg%3Apro&pageMode=MN&cc=US&lc=eng> >> >> There are 6 downloadable manuals - three Reference Guides, 2 users >> manuals and a service manual. >> >> Mike WA6ILQ >>Like I said, Im new to testing procedures with this type of unit, > yes Ive done the 20second search in my situation it took 5seconds to > findallthe manuals, however good those manuals are they dont get very > specific to testing duplexers,like Isaid im a novice at this so all > the manuals we can find searchingthe agilent site arenot going to do > any goood unless I can find someone who has some patience with > someone who has no experience and has already dealt with this > type/pieceof equipment.....but thanks anyway! > > > > > > ------------------------------------ > > > > Yahoo! Groups Links > > > >
