I have a very old MCC RC-100 repeater controller board. This is one of the ones that originally was not re-programmable. The firmware was upgraded (to version 2.03) and a small EEPROM board was added to replace the original 4 DIP switches. We had set up the remote base function years ago. The remote base radio died so we did not use that feature for several years. We have just added a different remote base radio. In the process, we had to do a hard initialization to clear out the EEPROM and are starting from scratch. Everything works fine except the remote base turn off code, which our old cheat sheets show as #B. It does not work. When going into the programming mode, we use the 4 digit code to reset and re-program the Remote Base Off code and it does nothing. We have had no problem programming anything else - we have verified that all digits are decoded properly (using the pad tester function). The only manual we can find on line is for a much later firmware version (there are two versions on the Repeater Builder website) and of course the only version available from the manufacturer is the current one. Does anyone have a very old version 2. something manual that I could get a copy of? I would like to have reasonably close schematics and parts layout at the very least and we are wondering if there was a long forgotten change in the programming of that code between then and now. I have already spoken with the manufacturer about this and tried all of his suggestions without any luck.
Thanks, and 73, Dan
