--- In [email protected], "Jared" <ke4...@...> wrote:
>
> I've been trying for the past 2 days to get my PURC5000 w/ Advanced
> Control to work with an RC-210 controller. I figured out the PTT, but it
> won't transmit any audio. All I'm getting
> is a dead carrier. So far, here's what I've done:
>
>
> RC-210 PURC J2
> ------ -------
> PTT-------------->Ext Key Request (pin 9)
> GND-------------->Logic Gnd (pin 7) and Analog Gnd (pins 1 & 2)
> TX Audio--------->Ext Aux Audio (pin 22)
>
>
> I've also tied 9.6V (pin 15) to Ext Mode Request (pin 24). My manual says to
> do this when you want to key analog audio.
>
> I've also tried tying TX Audio from RC-210 to Line 1 WIB (pin 25) instead of
> Ext Aux Audio, but still no dice.
>
> The weird part is that if I go into the service menu and tell it to "key up
> and pass audio", it transmits properly. However when I try to call for PTT
> via J2, no audio. When I call for PTT via J2, I can look at the stats menu
> and see that it's calling for "PTT for analog" and not binary which appears
> correct.
>
> Any ideas where I can put TX audio and get it to transmit right? I've set up
> the menu items to call for local control.
> Any help would be greatly appreciated.
>
> Thanks,
>
> Jared
>
>
> --- In [email protected], "wb0vhb" <rande1@> wrote:
> >
> > Looking for someone who has successfully interfaced a repeater
> > controller to a VHF PURC5000 with an Advanced Control.
> >
> > I'm attempting to use a Zetron Model 48B to encode PL tones.
> >
> > Need to know where to inject transmit audio and PL encode tones as
> > well as PTT.
> >
> > Randy
> > WB0VHB
> >
>
all acb wiring is the same is the disable light on ? i have them on vhf uhf and
900mhz you might have mis counted try grounging the ptt with out the controler
pin 9 just to the rack it should key up the tmiter [email protected] off list
