I've used 1/4" superflex with PL259 & reducer. Works fine. Seems like I had 
to drill the reducer, but that's easy anyway.

Chuck
WB2EDV



----- Original Message ----- 
From: <[email protected]>
To: <[email protected]>
Sent: Monday, August 31, 2009 2:23 PM
Subject: [Repeater-Builder] Re: UHF Connectors for 1/2 Andrew Superflex


Jim,
 Thank you VERY much for trying this and letting me know. That will save me 
a lot of time with this project.

 I have read an article that uses 1/4" superflex with PL259 and UG176 
reducers, and will order some new cables and connectors for the jumpers I 
need. Superflex is cheaper than RG214 and probably better shielded.

Tony



--- In [email protected], "Jim Cicirello" <ka2...@...> wrote:
>
> Tony,
>
>
> I just took a piece of ½" Superflex that previously had a connector on it
> and tried to place a PL259 UHF MALE  on it. The corrugation on the 
> superflex
> is larger than the ID of the connector. The connector will go over the
> center dielectric but the copper corrugation on the superflex is slightly
> larger than the outside of the UHF Male. The only way I can see it may be
> possible to join the connector to the cable would be to have a sleeve 
> extend
> over the superflex and the outside of the UHF connector and then solder 
> the
> sleeve. This might not be as good of an idea as getting proper connectors
> that fit the superflex like the N Male and use an adapter to get to UHF.
>
>
>
>
>
> Good Luck  JIM  KA2AJH
>
>
>
>
> From: [email protected]
> [mailto:[email protected]] On Behalf Of Tony KT9AC
> Sent: Monday, August 31, 2009 12:51 PM
> To: [email protected]
> Subject: [Repeater-Builder] UHF Connectors for 1/2 Andrew Superflex
>
>
>
>
>
> Hello Everyone,
> I need to make some short jumpers UHF-male to UHF-male and have a
> length of 1/2 Andrew Superflex on order (actually eBay). Can I use
> regular silver-teflon PL259's with this cable, similar to how 1/4"
> superflex is used with the reducer? I can't find UHF Male connectors for
> 1/2" superflex at Tessco.
>
> Thanks,
> Tony
>




------------------------------------



Yahoo! Groups Links



Reply via email to