Jef I was starting from the beginning - on the receiver. Am going through the steps again later this week. Will contact you with any questions. Also, thanks for your offer, Bob. will contact you if needed Chas, KS3Z
--- On Sat, 11/21/09, Jeff DePolo <[email protected]> wrote: From: Jeff DePolo <[email protected]> Subject: RE: [Repeater-Builder] GE MVP tuneup To: "'Charles Schmell'" <[email protected]> Date: Saturday, November 21, 2009, 6:08 PM I can help you if you get stuck. Are you having a problem with the exciter or receiver tuning? --- Jeff WN3A > -----Original Message----- > From: [email protected] > [mailto:[email protected]] On Behalf Of Charles Schmell > Sent: Saturday, November 21, 2009 5:59 PM > To: [email protected] > Subject: [Repeater-Builder] GE MVP tuneup > > > > Greeting, all, I am trying to tune up a high-band MVP > to use as a backup repeater for our club in SE Pennsylvania. > I have read the procedures on RB, and on the NHRC site. > > I have the ICOMs, and the GE test set. > > Unless there is a problem with the test set, I can't > figure out the tuning. It goes well to a point, but I just > seem to get lost. I figure if there's someone close to here, > that can "elmer" me in person, I would then know what the problem is. > > FYI, the radio worked fine on the original 155.xx frequencies. > > Email either on the list, or private, to: > [email protected] <mailto:[email protected]> > > Thanks, all! > > Charles, KS3Z > > > > > No virus found in this incoming message. > Checked by AVG - www.avg.com > Version: 8.5.425 / Virus Database: 270.14.61/2498 - Release > Date: 11/21/09 07:47:00 > > >
