The highband Mitreks I have used had 2 pots in the driver area. 1 for drive
level the other for output power. I have been able to adjust them to just
about any power though it is said they may not operate properly below 50%. The
pots are small plastic one blue and the other orange if I remember correctly.
You need a small screwdriver to adjust them
----- Original Message -----
From: cruizzer77
To: [email protected]
Sent: Sunday, December 06, 2009 9:59 AM
Subject: [Repeater-Builder] Making Mitrek output power adjustable, how?
There are tons of Mitrek mods out there but I haven't found the adjustable
output power mod. Therefore: Is it easily possible to make the output power
adjustable using a pot or trimmer? The desired model is a lowband Mitrek for a
6m repeater conversion.
73 Martin HB9TZW
