Good luck, Joe. I went through that drill a couple of years ago. I managed to get it all straightened out and documented, but it was quite a headache at the time.
73, Mike WM4B _____ From: [email protected] [mailto:[email protected]] On Behalf Of Joe Sent: Monday, December 07, 2009 8:52 PM To: [email protected] Subject: Re: [Repeater-Builder] Programming a CAT1000 Thanks Mike, This is an older cat1000 and not the B model. I'm trying to short-cut this repair to get it off my bench but it looks like I'm going to have to dig into things. This is an older Spectrum Communications repeater with the CAT1000 controller. The original builder is long gone and there are many mods done with no documentation. A small repair favor for a club looks like it's going to be in my basement for awhile until I figure things out. 73, Joe, K1ike Mike Besemer (WM4B) wrote: > Joe, > > Have you got a manual? If not, it's available on the CATAUTO website. > >
