Ouch. Maybe a regular nylon lock nut would work acceptably well and be a
little cheaper? Isn't the outer sleeve (the one that the lock nut threads
onto) slotted? If so, will it tighten up enough to keep the shaft from
beint turned if you just use a a regular nut?
--- Jeff WN3A
> -----Original Message-----
> From: [email protected]
> [mailto:[email protected]] On Behalf Of [email protected]
> Sent: Sunday, January 10, 2010 11:45 AM
> To: [email protected]
> Subject: RE: [Repeater-Builder] Motorola T1504A Duplexer Lock Nut
>
>
>
> At 1/10/2010 08:28, you wrote:
>
> >Try here:
> >
> >http://www.mcmaster.com/#hex-locknuts/=5bcw46
> <http://www.mcmaster.com/#hex-locknuts/=5bcw46>
> >
> >Click on "Flex-top Expanding Lock Nuts"
>
> McMaster-Carr - of course! Thanks Jeff.
>
> I do have one here with the lock nut: it's a 1/2"-20 thread. The best
> McMaster match to the original (same width & height) is
> 94830A550: $7.47 each.
>
> Bob NO6B
>
>
>
>
>
> No virus found in this incoming message.
> Checked by AVG - www.avg.com
> Version: 8.5.432 / Virus Database: 270.14.129/2605 - Release
> Date: 01/10/10 07:35:00
>
>
>
