I don't have the radio or manual with me at this time but I think you need to program scan by going to F2 then select zones then select scan. I have my Spectra set up for Zones so I can have a different scan for the Zone I select.
Hope this helps. David From: [email protected] [mailto:[email protected]] On Behalf Of Kris Kirby Sent: Sunday, January 31, 2010 12:05 AM To: [email protected] Subject: Re: [Repeater-Builder] Spectra Scan On Sat, 30 Jan 2010, N9WYS wrote: > I am trying to program my 900 MHz Spectra for SCAN. This radio is > modified for Conventional/Zones/MPL (with >120 modes). When I go into > the CONVENTIONAL CONFIGURATION screen, I have no ability to select > SCAN (neither ENABLED nor DISABLED) - NOTHING shows in the menu at > all. > > I MUST be missing something, but I can't for the life of me figure out > what it may be. I have the following MOFLAGS set: > > Bit Flag Setting > 2 3 Conv_With_Sys_Scan = ENABLED > 3 5 Conv_Message = ENABLED > 3 7 Conv_Status = ENABLED > 5 2 Conv_OpSel_Scan = ENABLED > 5 6 NonPri_Mode_Slaved_Scan = ENABLED > 5 7 Pri_Mode_Slaved_Scan = ENABLED > > What do I need to turn on in the MOFLAGS to get this to scan?? If you use the example MOFLAGS from Batlabs, the radio will be open to almost any feature the MLM supports. So if you use those MOFLAGS and it doesn't work, you probably need to change the MLM to one that supports conventional scan. -- Kris Kirby, KE4AHR Disinformation Analyst
