I am working on adding a controller to an S-7R UHF repeater. I do not have the manual for it. It has a simple controller which I understand has to be bypassed. I pulled off the two header connectors going to the controller which, of course, disabled it. I made up a wiring harness using the legend on top of the transmitter. I have power and RX audio. I have no COR or PTT. Was I supposed to pull only one of the connectors? Is a jumpper needed somewhere? Just thought I'd ask the questions before making myself nuts tracing wires. Anyone have the manual for this beastie? I'll check back for answers or my direct email is blair at uddle dot com.
PS the control board I am attempting to install is of my own design and was done for a friend (who actually owns this repeater). It has a CW IDer, dual multi-tone courtesy tones, hang time, time out timer, and audio switch. Either courtesy tone can also be 1-5 cw characters. Everything gets programmed with 2 buttons and stored in non-volatile memory. He wanted 20 of them but I went and made 100. This will perhaps be of interest to someone. The goal was not to make a full blown controller as much as a custom courtesy tone generator.
