Hello Steve,
Few months ago I got 2 defective antennas from a 911 project, they are made by Bluewave BME139FN1HO (identical to SRL 210C-2). The phasing harness was good and like new without any corrosion but inside a junction connector I found a cold join. If you want to have a look on my restoration job, go on my forum at this address: http://ve2rey.easyforum.fr/positionnement-gps-aprs-telemetrie-f6/nouveau-dig i-aprs-au-massif-du-sud-t120.htm?sid=d67005c214fd3a50e821c3cbe0a01e11 All the discussions are in French but you will found a lots of photos. Have fun 73 Eric VE2VXT / VE7YBC _____ De : [email protected] [mailto:[email protected]] De la part de steve.lenaghan Envoyé : 10 mars 2010 20:42 À : [email protected] Objet : [Repeater-Builder] Sinclair 210C8 questions Our club has two 210C8 antennas, one on a 48" triangular tower and one in a barn being stored. 1- Both antennas seem to have a problem with a failed T connection where the upper and lower segments join. Any hints to effect a good repair without butchering the antenna. 2- We would like to hook up both either: - one above the other with an appropriate phasing harness - or the two beside each other on the sides of the tower either on the corner or the flat. I'm not sure this would be a situation without a lot of pattern issues. 73 Steve VE6VS __________ Information from ESET NOD32 Antivirus, version of virus signature database 4933 (20100310) __________ The message was checked by ESET NOD32 Antivirus. http://www.eset.com
