Joe, Yes, indeed! The UHF high-power version will likely either go spurious or burn up if set that low. The only way to go with the radio you have is to add a 6 or 10 dB power attenuator rated at no less than 25 watts, and set your TX power at the low end. Admittedly, this is a "kluge" of the first degree, but hey- you asked!
Otherwise, try to get your hands on one of the 1-to-10 watt R1225 units, and you can have a ball. I suppose you could modify your high-power R1225 into the low-power version, but that is a lot of work, and the opportunities for permanently damaging the mainboard are legion. 73, Eric Lemmon WB6FLY -----Original Message----- From: Repeater-Builder@yahoogroups.com [mailto:repeater-buil...@yahoogroups.com] On Behalf Of Joe Sent: Thursday, July 29, 2010 6:45 PM To: Repeater-Builder@yahoogroups.com Subject: [Repeater-Builder] Adjusting low power on an R1225 repeater Hello to All, I want to turn the power down on my Motorola R1225 repeater to about 5 watts. It is the high power UHF version (25-45 watts). The reason for the low power is to drive a power amp at the output I want to achieve. Any drawbacks to running the R1225 this low? 73, Joe, K1ike
