Hi John, I am certain this wire goes to the audio squelch board that is under the front panel....where does it hook up there??
73s Steve --- In [email protected], "John J. Riddell" <ve3...@...> wrote: > > Steve, that orange wire is "Channel Guard disable". It goes to P1001, J910, > then to J1001 on the Channel Guard board. > > 73 John VE3AMZ > > > > ----- Original Message ----- > From: "steve" <w4...@...> > To: <[email protected]> > Sent: Saturday, August 07, 2010 8:08 PM > Subject: [Repeater-Builder] MVP problem > > > > Hello all, > > > > A friend gave me his MVP UHF repeater to work on. The audio squelch board > > was bad and I replaced it. I made what I HOPE was all the tracings and > > jumper connections on this board by copying the old board. The problem is > > that there is NO audio on the transmitter output when the squelch is > > opened up. I can hear squelch fine on the transmit output when I press the > > TEST switch on the front. The squelch control has no effect of course on > > the squelch while in the test position. There is an ORANGE wire that is > > connected to this switch on the front but is not connected-like it is > > broken off from the board. Does this have anything to do with the squelch? > > The repeater keys up fine when I open the squelch but no squelch noise is > > present-like it is being muted. When I press the test switch I can hear my > > audio on a monitor receiver fine when I transmit thru the repeater with my > > hand held. WHERE does this orange wire from the switch go? Is this the > > problem? > > > > Thanks for any help! > > > > Steve W4SEF > > > > > > > > ------------------------------------ > > > > > > > > Yahoo! Groups Links > > > > > > >
