firstly, i guess a lot comes down to your wallet i would if i was going to make a small time PRS repeater, prefer to use maybe a couple of Tait 2020's and ( Duplexor versus twin aerials ) tin shed up on the hill out back versus a 40meter high ( Or more ) tower
don't get me wrong t555 are the old trunking mobiles, which yes can be reconfigured for multichannel use on the prs band, trim the hockey sticks a bit and bring the freq up a bit ( i am about to as soon as money allows me to , build a single channel repeater out of 2 T2035's just saving for the line cards you stated ( I was curious as to setting frequencies on these with the diode matrix and worked out the frequencies these were set on and a couple of small holes drilled through the heatsink.. Any help would be great..) do you have the diode matrix software or papers ( Service manual )to set the matrix board, or did you use a frequency counter just trying to get a better picture of your message Not sure what to make of the 2 holes in the heatsink, short of made there for someone to poke wires in or out of Back to you Marcus On Tue, Aug 17, 2010 at 9:17 PM, Floydiboy007 <[email protected]> wrote: > > > Hi all. > This is my first on this group.Better late than never. Is there anyone out > there that may have had something to do with building a UHF PRS repeater > from the above radios. I have two of them and I think that before I bought > them they may have already been in a repeater config. I was curious as to > setting frequencies on these with the diode matrix and > worked out the frequencies these were set on and a couple of small holes > drilled through the heatsink.. Any help would be great.. > Cheers Mike > > >
