Thanks Niteviser, Will examine further, looking at the board it appears that there is only one data line plus ground so that rules out the normal type level converter circuit.
Thanks again for the link. Regards, Chris S. --- In [email protected], "niteviser" <nitevi...@...> wrote: > > This what you are looking for? > > http://www.batlabs.com/svr200.html > > niteviser > > --- In [email protected], "tait700" <cscannel@> wrote: > > > > Hello, > > > > Was wondering if anyone happened to know how the programming cable is wired > > for the above pyramid in vehicle repeater ? > > > > Cable has a part No. of " FY-1 " > > > > I don't know if the Genuine version has some electronics inside the DB9 > > plug cover as with the T800 SII that changes levels, etc. > > > > The unit has a 2.5mm jack to accept the data from the computer and a db9 > > plug at the other end to connect to the serial port at the computer. > > > > I have a standard RS232 interface box i use for Tait stuff that provides > > Tx, RX, Gnd outputs but i was wondering if it would be as simple as l + R + > > ground on the 2.5 stereo plug. > > > > I have seen the file that uses the Motorola programming box at the Batlabs > > site but if i could avoid having to purchase one of those solely for this > > use i would prefer it. > > > > Any info or suggestions gratefully received. > > >
