Hi Chris, On Thu, Jun 09, 2016 at 10:44:28PM -0400, chris stolarik wrote: > > I've downloaded linx-socfpga-gsrd-15.1-av-bin.tar.gz from > https://releases.rocketboards.org/release/2015.10/gsrd/bin/. When I use > this image, eth0 is not functioning. Near the end of the kernel boot the > following error message is seen: > > stmmac_open: DMA initialization failed
I've run into that same error (also running 3.10 kernel). In our case, it appears to be caused by the RX clock not running. The clock is normally provided from the PHY chip. So you might check that your PHY chip is correctly hooked up, and that it is not held in reset. Regards, Ralph _______________________________________________ Rfi mailing list [email protected] http://lists.rocketboards.org/cgi-bin/mailman/listinfo/rfi
