Hi All,
When I started using NetworkManager I was quite impressed. It
seemed to work quite well and remembered the wireless networks I use. Now
however it fails to realise that the wireless card (ipw3945) has
successfully associated with an access point. Here is a bit of the log
file when this happens;
Apr 5 09:26:27 antonia NetworkManager: <information> Device eth1
activation scheduled...
Apr 5 09:26:27 antonia NetworkManager: <information> Activation (eth1)
started...
Apr 5 09:26:27 antonia NetworkManager: <information> Activation (eth1)
Stage 1 of 5 (Device Prepare) scheduled...
Apr 5 09:26:27 antonia NetworkManager: <information> Activation (eth1)
Stage 1 of 5 (Device Prepare) started...
Apr 5 09:26:27 antonia NetworkManager: <information> Activation (eth1)
Stage 2 of 5 (Device Configure) scheduled...
Apr 5 09:26:27 antonia NetworkManager: <information> Activation (eth1)
Stage 1 of 5 (Device Prepare) complete.
Apr 5 09:26:27 antonia NetworkManager: <information> Activation (eth1)
Stage 2 of 5 (Device Configure) starting...
Apr 5 09:26:27 antonia NetworkManager: <information> Activation
(eth1/wireless): access point 'sgowdy.org' is unencrypted, no key needed.
Apr 5 09:26:27 antonia NetworkManager: <information> SUP: sending
command 'INTERFACE_ADD eth1 wext /var/run/wpa_supplicant '
Apr 5 09:26:27 antonia NetworkManager: <information> SUP: response was
'OK'
Apr 5 09:26:27 antonia NetworkManager: <information> SUP: sending
command 'AP_SCAN 1'
Apr 5 09:26:27 antonia NetworkManager: <information> SUP: response was
'OK'
Apr 5 09:26:27 antonia NetworkManager: <information> SUP: sending
command 'ADD_NETWORK'
Apr 5 09:26:27 antonia NetworkManager: <information> SUP: response was
'0'
Apr 5 09:26:27 antonia NetworkManager: <information> SUP: sending
command 'SET_NETWORK 0 ssid 73676f7764792e6f7267'
Apr 5 09:26:27 antonia NetworkManager: <information> SUP: response was
'OK'
Apr 5 09:26:27 antonia NetworkManager: <information> SUP: sending
command 'SET_NETWORK 0 key_mgmt NONE'
Apr 5 09:26:27 antonia NetworkManager: <information> SUP: response was
'OK'
Apr 5 09:26:27 antonia NetworkManager: <information> SUP: sending
command 'ENABLE_NETWORK 0'
Apr 5 09:26:27 antonia NetworkManager: <information> SUP: response was
'OK'
Apr 5 09:26:27 antonia NetworkManager: <information> Activation (eth1)
Stage 2 of 5 (Device Configure) complete.
Apr 5 09:26:28 antonia avahi-daemon[4371]: New relevant interface
eth1.IPv6 for mDNS.
Apr 5 09:26:28 antonia avahi-daemon[4371]: Joining mDNS multicast group
on interface eth1.IPv6 with address fe80::213:2ff:fe3c:8c7c.
Apr 5 09:26:28 antonia avahi-daemon[4371]: Registering new address record
for fe80::213:2ff:fe3c:8c7c on eth1.
Then it just spins at that point even though I can see it is associated
with iwconfig (and the external light goes steady for the network card
meaning it has associated).
[EMAIL PROTECTED] ~]# iwconfig eth1
eth1 IEEE 802.11g ESSID:"sgowdy.org"
Nickname:"antonia.sgowdy.org"
Mode:Managed Frequency:2.462 GHz Access Point: 00:09:5B:53:42:B6
Bit Rate:54 Mb/s Tx-Power:14 dBm
Retry limit:15 RTS thr:off Fragment thr:off
Encryption key:off
Power Management:off
Link Quality=89/100 Signal level=-43 dBm Noise level=-44 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:5 Missed beacon:0
Any ideas?
regards,
Stephen.
--
/------------------------------------+-------------------------\
|Stephen J. Gowdy, SLAC | CERN Office: 32-2-A22|
|http://www.slac.stanford.edu/~gowdy/ | CH-1211 Geneva 23 |
|http://calendar.yahoo.com/gowdy | Switzerland |
|EMail: [EMAIL PROTECTED] | Tel: +41 22 767 5840 |
\------------------------------------+-------------------------/
_______________________________________________
rhelv5-list mailing list
[email protected]
https://www.redhat.com/mailman/listinfo/rhelv5-list
